Autostart AS-1251 Instructions d'exploitation télécharger pdf (Page 77)

Code English output Description

024 SW Pump 2 old Software version of pump 2 too old

025 SW Pump 3 old Software version of pump 3 too old

026 SW HTC old Software version of high temperature cooler too old

027 SW Ext. Pt100 old Software version of external Pt100 too old

028 SW Ethernet old Software version of Ethernet too old

029 SW EtherCAT old Software version of EtherCAT too old

033 Clock wrong time Internal clock defective; supply with battery was/is interrupted.

034 Tset: Prog. is running Setpoint was changed while the programmer is running.

041 Wrong mains voltage Incorrect mains voltage setting

042 No VC type Device type not configured

043 No VC voltage Mains voltage not configured

051 Niveau high High level (fill level of the heat transfer liquid too high, risk of bath

overflowing)

055 CAN buff. overflow Buffer overflow for CAN reception

8.6

Warnings – safety system

All warnings of the safety system start with the prefix 1.

The prefix is followed by two other digits. These digits

are listed in the following table.

Code English output Description

101 CAN receive overflow Overflow during CAN reception

102 Watchdog Reset Watchdog reset

103 Heating not correct Heaters have different outputs

104 Heat 1 failed Heater 1 defective

105 Heat 2 failed Heater 2 defective

106 Heat 3 failed Heater 3 defective

107 Invalid Parameter Inadmissible parameter in memory

108 CAN system Problem during internal data exchange

109 Unknown Modul Unknown module connected

110 SW Control too old Software version of control system too old

111 SW Safety too old Software version of safety system too old

112 SW Command too old Software version of command remote control unit too old

Faults

Variocool 77

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 103 104

Pas de commentaire

Autostart AS-1251 Instructions d'exploitation Page 77